Hawking Technology H-BR49 - Manual (Page 25)

Figure 10
Modify the Configuration Port:
1. Click the checkbox to enable this function.
2. Input the port number for web configuration. The default web port for
configuration is set to 80. If you want to change the default setting, input the
appropriate port number. Once the web configuration has been modified,
configuration over the web should be changed with the new setting (e.g., if
the web configuration port is set to 8080, you will need to input the address
as follows to login the web configuration:
http://192.168.1.254:8080 (where
192.168.1.254 is your local port IP address).
After changing the settings, click SAVE to save them, or click UNDO to clear all the
settings on this page.
Virtual Server
In this page, you can set up a local server with a specific port number that stands
for the service (e.g. web(80), FTP(21), Telnet(23)). When this device receives an
incoming access request for this specific port, it will be forwarded to the
corresponding internal server. You can add virtual servers either by port number
or by name.
A maximum 24 Server entries are allowed and each port number can only be
assigned to one IP address.
NOTE: Setting up a Virtual Server is like opening the firewall, which exposes
your network to users on the Internet. This means the IP Share’s NAT will no
longer be able to provide protection from hackers.