Humax PVR-8000 - Manual (Page 33)

GB GB31
Main Menu Guide
Enter the PIN code to access the Channel Searching menu as
you access the Parental Control menu.
Press the
OK button to start Service Search after setting the
parameters.
** The default PIN code is
.
Channel Search consists of 5 sub menus.
Antenna Configure enables you to set the installation state of an
antenna connected to your STB. You can select using the
OK
button and toggle between Single and Dual.
When Single is selected (this means one signal source is
present), an antenna should be connected to Tuner A directly
and an input for recording should be connected to tuner B.
Two methods are used for connection to Tuner B; one is splitter,
another is loop through.
When Dual is selected (this mean two signal sources are present),
Tuner A performs search. Dual allows two identical signal sources
to be input to two different inputs and enables you to view during
recording regardless of different polarities. Tuner A performs oper-
ations, such as search.
Selects the antenna and LNB settings for Service search.
As you can change the settings for 22KHz Tone and DiSEqC
switch, there are 32 possible Antenna Setting for use.
The values that are set in this menu will be available for selection
in other channel searching menus.
There are 32 antenna alternatives, each one can have different
combinations of settings for 22KHz Tone and DiSEqC switch.
4. Channel Search
0000
Antenna Configure
Antenna Setting
Antenna Alternative
PVR-8000 ENG 1/21/03 11:10 PM Page 36