Document Outline

• Contents
• Proprietary Statement
• Declaration of Conformity
• Warranty Information
• Preface
  • Contacts
    • Support
  • Document Conventions
  • Related Documents
• Introduction
  • External View
  • Front Panel
    • LCD Display Settings
    • Print Modes
  • Printer Media Compartment
• Printer Setup
  • Before You Begin
  • Unpack and Inspect the Printer
    • Report Damage
    • Storage
  • Select a Site for the Printer
    • Select a Surface
    • Provide Proper Operating Conditions
    • Allow Proper Space
    • Provide a Data Source
  • Connect the Printer to a Power Source
    • Power Cord Specifications
  • Select a Communication Interface
    • Cable Requirements
  • Types of Media
    • Selecting Media
    • Non-Continuous Media
    • Continuous Media
  • Ribbon
    • When to Use Ribbon
    • Ribbon Width
    • Coated Side of Ribbon
• Printer Operation
  • Front Panel
    • Front Panel Keys
    • Front Panel Lights
  • Load Roll Media
    • Tear-Off Mode
    • Cutter Mode
    • Peel-Off Mode
    • Liner Take-Up Mode
    • Rewind/Peel-Off Mode
    • Rewind Mode
    • Adjust Media Alignment for Rewind Option
  • Load Fanfold Media
  • Load the Ribbon
    • Remove the Ribbon
  • Calibrate the Printer
    • Auto Calibration
    • Manual Calibration
  • Print a Configuration Label
  • Print a Network Configuration Label
  • Adjust Printhead Pressure
  • Install Memory Card
• Configuration
  • Overview
    • Enter Configuration Mode
    • Exit Configuration Mode
    • Change Password-Protected Parameters
  • Basic Configuration
  • Configuration and Calibration LCD Displays
    • ZebraNet®Wired and Wireless Print Server LCD Displays
• Routine Care and Adjustments
  • Cleaning Procedures
    • Clean the Exterior
    • Clean the Interior
    • Clean the Printhead and Platen Roller
    • Clean the Sensors
    • Clean the Rewind Option
    • Clean the Peel-Off Assembly
    • Clean the Cutter Module
  • Lubrication
  • Fuse Replacement
  • Position the Label Sensor
    • Adjust the Reflective Sensor
    • Select the Transmissive Sensor
• Troubleshooting
  • LCD Error Conditions and Warnings
  • Print Quality Problems
  • Calibration Problems
  • Communication Problems
  • Miscellaneous
  • Printer Diagnostics
    • Power-On Self Test
    • CANCEL Self Test
    • PAUSE Self Test
    • FEED Self Test
    • FEED and PAUSE Self Test
    • Communication Diagnostics Test
  • Loading Factory Defaults
• Data Connections
  • Serial Data Port
    • Hardware Control Signal Descriptions
    • RS-232 Serial Data Port
  • Parallel Data Port
    • Parallel Cabling Requirements
    • Parallel Port Interconnections
• Specifications
  • General Specifications
  • Printing Specifications
  • Media Specifications
  • Ribbon Specifications
  • Printer Options
  • Zebra Programming Language (ZPL II) Features
  • Supported Bar Codes
• Index