Unpack and inspect the printer, Report damage, Storage – Zebra Technologies Z6Mplus User Manual
Page 27: Report damage storage
Printer Setup
Unpack and Inspect the Printer
13163L Rev. 3 5/20/2004
Z4Mplus/Z6Mplus User Guide
9
Unpack and Inspect the Printer
• Check all exterior surfaces.
• Raise the media door, and inspect the media compartment.
• Save the carton and all packing material in case the printer needs to be shipped. Contact
your authorized Zebra reseller for instructions.
Report Damage
If you discover shipping damage:
• Immediately notify the shipping company and file a damage report.
• Keep the carton and all packing material for inspection.
• Notify your local Zebra reseller.
Storage
If you are not placing the printer into operation immediately, repackage it using the original
packing materials. The printer may be stored under the following conditions:
• Temperature: –40°F to 140°F (–40°C to 60°C)
• Relative humidity: 5% to 85%, non-condensing
Important •
Zebra Technologies Corporation is not responsible for any damage incurred
during the shipment of the equipment and will not repair this damage under warranty