Zebra Technologies Z6Mplus - Manual (Page 80)

62 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004
Configuration
Configuration and Calibration LCD Displays
INIT FLASH MEM Initialize Flash Memory
Caution • Perform this operation only when it is necessary to erase all previously
stored information from the FLASH memory. Press PLUS (+) to bypass this
function.
1. Press SELECT to select the parameter.
If your printer is set to require a password, you are prompted to enter the password.
2. Enter the password, then press SELECT.
3. Press PLUS (+) to select YES.
The display asks
INITIALIZE FLASH? .
4. Press PLUS (+) to select YES .
The front panel LCD asks ARE YOU SURE? .
5. Press MINUS (–) to select NO and cancel the request. The INITIALIZE FLASH
prompt is displayed.
or
Press PLUS (+) to select
YES and begin initialization. Depending on the amount
of free FLASH memory, initialization may take up to one minute to complete.
6. Press SETUP/EXIT followed by SELECT. If initialization is still in process,
the front panel display flashes back and forth between the phrases
CHECKING E: MEMORY and PRINTER IDLE .
When initialization is complete, the printer automatically exits the configuration
mode and the front panel displays
PRINTER READY .
7. Press SELECT to continue with the next prompt.
SENSOR PROFILE Sensor Profile
The media sensor profile may be used to troubleshoot registration problems that may be
caused when the media sensor detects preprinted areas on the media or experiences
difficulty in determining web location. If the sensitivity of the media and/or ribbon
sensors MUST be adjusted, use the manual calibration procedure.
Figure 32 • Media Sensor Profile
1. Press SELECT to select the parameter.
2. Press PLUS (+) to print a media sensor profile.
3. Press SELECT to deselect the parameter.
Table 9 • Printer Parameters and Other LCD Displays (Sheet 6 of 15)
Parameter Action/Explanation