Zebra Technologies Z6Mplus - Manual (Page 55)

Printer Operation
Load Roll Media
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 37
Adjust Media Alignment for Rewind Option
The instructions below apply only if the printer has a Rewind option. The liner should be
installed flush against the backplate of the rewind spindle to prevent the media/backing from
winding too loosely. See
Figure 24 .
Do the adjustments in the order given. Do only what is needed to solve the problem.
Figure 24 • Rewind Option Adjustment Dial
To adjust the Media Alignment for Rewind Mode, complete these steps:
1. Turn the adjustment dial clockwise to move the media toward the mainframe.
2. Turn the dial counter clockwise to move the media away from the mainframe.
1 Rewind Spindle Backplate
2 Rewind Spindle
3 Adjustment Dial
4 Printhead Assembly
1
2
4
3