Print a configuration label – Zebra Technologies Z6Mplus User Manual
Page 61
Printer Operation
Print a Configuration Label
13163L Rev. 3 5/20/2004
Z4Mplus/Z6Mplus User Guide
43
Print a Configuration Label
Print a configuration label to test the printer setup. Do this when the printer is first installed, or
when the printer cannot properly detect the top of the label.
To print a configuration label, complete these steps:
1.
Turn the printer power Off (
O
).
2.
Press and hold CANCEL while turning the printer On (
l
). See
Figure 3, Front Panel
Controls and LEDs, on page 3
.
3.
Release CANCEL after the DATA light turns off (approximately five seconds).
A configuration label prints showing the printer’s currently stored parameters (similar to
the labels shown in
Figure 28
).
Figure 28 • Sample Configuration Labels
Z6Mplus - 300dpi
4
4
Z4Mplus - 200dpi