Clean the rewind option – Zebra Technologies Z6Mplus User Manual

Page 98

Advertising
background image

80

Z4Mplus/Z6Mplus User Guide

13163L Rev. 3 5/20/2004

Routine Care and Adjustments

Cleaning Procedures

Clean the Rewind Option

The Rewind option is required. Refer to

Figure 36

and perform the following procedure if

adhesive buildup begins to affect peel performance.

Figure 36 • Cleaning the Rewind Option

To clean the Rewind option, complete these steps:

1.

Open the printhead assembly.

2.

Close the peel assembly to prevent bending the tear-off/peel-off bar during cleaning.

3.

Use the Preventive Maintenance Kit (Zebra part number 47362) or a solution of
90% Isopropyl alcohol and 10% deionized water and swab to remove excess adhesive
from the tear-off/peel-off bar. Allow the solvent to evaporate.

4.

Open the peel assembly by pivoting the module toward you.

5.

Manually rotate the pinch roller and clean thoroughly with solvent and a swab. Allow the
solvent to evaporate.

6.

Close the peel assembly.

7.

Close the printhead assembly.

1

Printhead Assembly

2

Tear-Off/Peel-Off Bar

3

Pinch Roller

4

Peel Assembly

3

2

1

4

Caution • Ensure that the printhead is fully open and engaged in the up position. If the
printhead is not latched in the up position, it could fall on your hand during the
procedure.

Note •

Apply minimum force when cleaning the tear-off/peel-off bar. Excessive force can

cause the tear-off/peel-off bar to bend, which can have a negative effect on peel
performance.

Advertising