Zebra Technologies Z6Mplus - Manual (Page 69)

Configuration
Overview
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 51
Exit Configuration Mode
You can leave configuration mode at any time.
To exit configuration mode, complete these steps:
1. From the front panel, press SETUP/EXIT.
The
SAVE CHANGES display appears.
2. Press PLUS (+) or MINUS (–) to scroll through the choices ( Table 8 ):
3. Press SELECT to select the displayed choice.
4. Press SETUP/EXIT to save your choice.
Table 8 • Save Options When Leaving Setup Mode
LCD Display Description
PERMANENT Permanently saves the changes. Values are stored in the printer even when power
is turned off.
TEMPORARY Saves the changes until you change them again or until power is turned off.
CANCEL Cancels all changes from the time you pressed SETUP/EXIT except the
darkness and tear-off settings (if they were changed).
LOAD DEFAULTS Sets all parameters other than the network settings back to the factory defaults.
To see the factory default values, see
Configuration and Calibration LCD
Displays on page 57 .
Note • Loading factory defaults causes the printer to auto-calibrate.
LOAD LAST SAVE Loads values from the last permanent save.
DEFAULT NET Sets the wired and wireless network settings back to factory defaults.