Zebra Technologies Z6Mplus - Manual (Page 45)

Printer Operation
Load Roll Media
13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 27
6. Slide in the media supply guide until it touches, but does not restrict, the edge of the roll.
7. Feed the media under the dancer, through the slot in the transmissive sensor, under the
ribbon sensor, and through the cutter module.
8. Ensure that the media is against the back of the transmissive sensor. Then, slide in the
media guide until it touches, but does not restrict, the edge of the media.
9. Close the printhead assembly.
10. If the printer is paused (the Pause light is on), press PAUSE to enable printing.
Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.