FARGO electronic 76503 - Manual (Page 25)

PrimeraPro readily accepts five different sizes of
print media: A-size (Letter), A4-size, A-long
(Letter-long), A4-long, and Legal-size. The A-long,
A4-long, and Legal-size print media are simply
extended-length sheets which allow for a larger
printable area. FARGO wax thermal transparency
film and T-shirt transfer paper are only available in
the A-long or A4-long sizes. Only the dye-
sublimation paper shipped with the 4-color dye-
sublimation ribbon is available in the Legal-size
paper.
Your PrimeraPro has an internal mechanical adjust-
ment that is factory-set for either A-size or A4-size
paper. If you need to change an A-size unit (all 110/120
VAC units) to an A4-size unit (all 220/250 VAC units)
or vice versa, refer to the following instructions: Please
note that all 220/250 VAC units must be internally set to
the A-size in order to print onto the Legal-size dye-
sublimation paper.
1. Open the top cover and remove the ribbon cartridge.
2. With the Paper Input Tray down, and the Paper
Output Tray (the clear plastic tray) removed,
unscrew and remove the only visible screw on the
Front Frame Plate of the printer.
3.
Gently slide the entire bronze-colored Output
Assembly, located just above the Paper Input Tray,
out about five centimeters (steps 1Ð3 are illustrated
up to this point on page 70 of this manual).
4.
Looking inside the printer, the Paper Feed Roller
and the two black brackets which attach it to the
printer should now be visible.
5.
To adjust from A to A4-size print media, gently
slide the left bracket to the right approximately .25Ó.
To adjust from A4 to A-size print media, do just the
opposite. The internal A/A4 adjustment is now
complete. Reverse these steps to reassemble.
4.
Slightly bend the
Paper Output Tray just
enough to place the
remaining mounting
post into the other
mounting hole. Lower
the tray into place.
While care should be
taken not to bend the
tray too much, donÕt
worry; the tray is not
easily broken.
F. Loading Paper
or Transparency
Film
23