2 electrical grounding requirements, 3 australian requirements – Frymaster FPH1721 User Manual

Page 11

Advertising
background image

EH1721 SERIES ELECTRIC FRYERS

CHAPTER 2: INSTALLATION INSTRUCTIONS

2-3

DANGER

This appliance must be connected to a power supply having the same voltage and phase as
specified on the rating plate located on the inside of the appliance door.

DANGER

All wiring connections for this appliance must be made in accordance with the wiring
diagram(s) furnished with the appliance. Refer to the wiring diagram(s) affixed to the inside
of the appliance door when installing or servicing this equipment.

DANGER

Frymaster appliances equipped with legs are for stationary installations. Appliances fitted
with legs must be lifted during movement to avoid damage to the appliance and bodily
injury. For movable installations, optional equipment casters must be used. Questions?
Call 1-800-551-8633.

WARNING

Do not attach an apron drainboard to a single fryer. The fryer may become unstable, tip over
and cause injury. The appliance area must be kept free and clear of combustible material at
all times.


In the event of a power failure, the fryer(s) will automatically shut down. If this occurs, turn the
power switch "OFF". Do not attempt to start the fryer(s) until power is restored.

This appliance must be kept free and clear of combustible material, except that it may be installed on
combustible floors.

A clearance of 6 inches (15 cm) must be provided at both sides and back adjacent to combustible
construction. A minimum of 24 inches (61cm) should be provided at the front of the equipment for
servicing and proper operation.


WARNING

Do not block the area around the base or under the fryers.

2.1.2 Electrical Grounding Requirements


All electrically operated appliances must be grounded in accordance with all applicable national and
local codes, and, where applicable, CE codes. A wiring diagram is located on the inside of the fryer
door. Refer to the rating plate on the inside of the fryer door for proper voltages.

2.1.3 Australian Requirements

To be installed in accordance with AS 5601 / AG 601, local authority, gas, electricity, and any other
relevant statutory regulations.

Advertising