2 fryer installation – Frymaster FPH1721 User Manual

Page 12

Advertising
background image

EH1721 SERIES ELECTRIC FRYERS

CHAPTER 2: INSTALLATION INSTRUCTIONS

2-4

2.2 Fryer Installation

WARNING

Frymaster fryers equipped with legs are for permanent installations. Fryers fitted with legs
must be lifted during movement to avoid damage and possible bodily injury. For a moveable
or portable installation, Frymaster optional equipment casters must be used. Questions?
Call 1-800-551-8633



1. To level fryers equipped with legs, the bottom of the legs can be screwed out up to 1-inch for

leveling. Legs should be adjusted so that the fryer is at the proper height in the frying station.
For fryers equipped with casters, there are no built-in leveling devices. The floor where the fryer
is installed must be level.

NOTE: If you need to relocate a fryer installed with legs, remove all the weight from each leg
before moving. If a leg becomes damaged, contact your service agent for immediate repair or
replacement.

WARNING

Hot shortening can cause severe burns. Avoid contact. Under all circumstances, oil
must be removed from the fryer before attempting to move it to avoid oil spills and
the falls and severe burns that could occur. This fryer may tip and cause personal
injury if not secured in a stationary position.

2. When the fryer is leveled in its final position, install the restraints provided with the unit to limit

its movement so that it does not depend on or transmit stress to the electrical conduit or
connection as well as to prevent tipping. Install the restraints in accordance with the provided
instructions (see illustration on the following page). If the restraints are disconnected for service
or other reasons, they MUST be reconnected before the fryer is used.


DANGER

Adequate means must be provided to limit the movement of this appliance without
depending on or transmitting stress to the electrical conduit. A restraint kit is
provided with the fryer. If the restraint kit is missing contact your local Frymaster
Factory Authorized Service Center (FASC) for part number 826-0900.

Advertising