Frymaster H14 Series User Manual
Page 19
3–9
2. Press and release the
switch until the word
DISPLAY appears in the left display.
3. Press the right
1
or
2
switch to toggle back and forth between constant product display
(
CONSTANT) or alternating temperature and product display (ALT).
4. Press the
switch to save the settings.
5. Press either ON/OFF switch
to exit the setup mode. Both displays will change to
OFF.
How to Calibrate Computer Temperature to Actual Frypot Temperature
NOTE: For this procedure, actual frypot temperature refers to the temperature of the oil in the frypot
as measured with a good-grade thermometer or pyrometer. The computer’s temperature can only be
adjusted
±5°F (±3°C). The computer cannot be adjusted to a temperature greater than 375°F (191°C).
1. Enter the setup mode. See How to Enter the Setup Mode on page 3-7.
1. Press and release the
switch until
CALIB
appears in the display.
1. Press the temperature check switch
. The frypot temperature sensed by the computer will be
displayed. In split-vat units, the temperatures for each side will be displayed.
1. For the left side of a split-vat: Press the left
1
switch to go UP a degree (maximum of 5 for
Fahrenheit or 3 for Celsius). Press the left
2
switch to go DOWN a degree (maximum of 5 for
Fahrenheit or 3 for Celsius).
For the right side of a split-vat or for a full-vat: Press the right
1
switch to go UP a degree
(maximum of 5 for Fahrenheit or 3 for Celsius). Press the right
2
switch to go DOWN a degree
(maximum of 5 for Fahrenheit or 3 for Celsius).
1. Press the
switch to save the settings.
1. Press either ON/OFF switch
to exit the setup mode. Both displays will change to
OFF.
How to Activate or Deactivate the Frypot BOIL-OUT Feature
0. Enter the setup mode. See How to Enter the Setup Mode at the beginning of this section.
0. Press and release the
switch until
BOIL-OUT appears in the display.
0. Press the right
1
or
2
switch to toggle the boil-out mode ON or OFF.
0. Press the
switch to save the settings.
0. Press either ON/OFF switch
to exit the setup mode. Both displays will change to
OFF.