Frymaster H14 Series - Manual (Page 24)

3–14
How to Display “Use Time” Information
NOTE: This feature is used to determine the total amount of time that a fryer has been cooking.
1. Enter the program mode. See How to Enter the Program Mode on page 3-10.
2. Press the left switch to display use time for the left side of a dual-vat unit. Press the right
switch to display use time for a full-vat unit or the right side of a dual-vat unit.
3. To reset use time data to zero, while pressing one of the switches, press the same side's 1 and
2 switches, then release them simultaneously.
NOTE: The simultaneous release of these three switches is critical. If not done correctly, data
will not reset.
How to Display the Product Cycle Accumulator Information
NOTE: This feature keeps a running total of cooking cycles per product.
1. Enter the program mode. See How to Enter the Program Mode on page 3-10.
2. Press the left or right switch.
3. For the left vat, press the switch. For the right or for a full-vat, press the switch. A running
total of cooking cycles per product will be displayed.
4. To clear the accumulated times from computer memory, press either
switch, then the
switch.
How to Use the Filter Countdown Timer
NOTE: This feature starts a five-minute countdown timer to time the polishing of vegetable oil
during the filtering process. Polishing refers to circulating the vegetable oil through the filtration
system for a specified time. This feature does not have any direct control over the filtration process; it
is only a timer.
1. With the computer ON, press and release the switch until FILTER appears in the display.
(For split-vat units, press and release the switch for the left vat.)
2. Press either of the right
1 or 2 switches. The computer will begin to countdown from five
minutes to zero. (For split-vat units, press either of the left 1 or 2 switches for the left vat.)