Frymaster H14 Series - Manual (Page 59)

7-9
7-6: REPLACE HIGH-LIMIT
1. Perform Procedure 7-4, Replace Temperature
Probe, Steps 1-4.
2. Disconnect the wire harness containing the
high-limit wires.
3. Use a pin-pusher to remove the two high-
limit wires from the wire harness connector.
For split-pot fryers, remove only the wires for
the high-limit to be replaced. Mark each wire
for re-assembly.
4. Remove the high-limit from the frypot using
an open-end wrench or other suitable tool.
5. Apply Loc-Tite PST 567 sealant to the
replacement high-limit threads.
6. Screw the replacement high-limit into the
frypot and tighten securely. DO NOT
OVERTIGHTEN.
7. Insert the replacement high-limit wires into
the proper pin-holes in the connector. The
same two pin-holes from which the defective
high-limit wires were removed.
8. Reconnect the wire harness connector.
9. Install and secure the back covers.
10. Position the fryer under the exhaust hood.
Pin Pusher— P/N 807-0928
Use a pin-pusher to remove high-limit wires from
connector
Place tool here when removing and installing high-
limit