Frymaster Gas Rethermalizers FBKR18 Series - Manual (Page 6)

1-1
FBCR18 & FBKR18 SERIES GAS RETHERMALIZERS
CHAPTER 1: GENERAL INFORMATION
1.1 Applicability and Validity
This manual is applicable to and valid for all FBCR18 and FBKR18 units sold in English-
speaking countries. Where conflicts exist between instructions and information in this manual
and local or national codes of the country in which the equipment is installed, installation and
operation shall comply with those codes.
This appliance is only for professional use and shall be used by qualified personnel only, as
defined in Section 1.6.
1.2 Parts Ordering and Service Information
In order to assist you as quickly as possible, the Frymaster Factory Authorized Service Center
(FASC) or Service Department representative requires certain information about your equipment.
Most of this information is printed on a data plate affixed to the inside of the door.
Parts orders may be placed directly with your local FASC or distributor. Included with the unit
when shipped from the factory is a list of FASCs. If you do not have access to this list, contact the
Frymaster Technical Service Department at 1-800-551-8633 or 1-318-865-1711.
When ordering parts, the following information is required:
Model Number:
Serial Number:
Gas Type:
Item Part Number:
Quantity Needed:
Service information may be obtained by contacting your local FASC/Distributor. Information may
also be obtained by calling the Frymaster Technical Service Department at 1-800-551-8633 or
1-318-865-1711. When requesting service, please have the following information ready:
Model Number:
Serial Number:
Gas Type:
In addition to the model number, serial number, and gas type, please be prepared to describe the na-
ture of the problem and have ready any other information that you think may be helpful in solving
your problem.
RETAIN AND STORE THIS MANUAL IN A SAFE PLACE FOR FUTURE USE.