Fostex VR800 - Manual (Page 10)

10
VR800 Owner’s Manual (Names and Functions)
ABS time
BAR/BEAT/CLK
MTC time
15. Time Base select key [TIME BASE SEL]
Pressing this key repeatedly will switch time base as follows:
13. JOG dial [JOG/ SHUTTLE ]
When the VR800 is stopped, use the JOG dial to perform a
jog operation (forward or reverse) for audio scrubbing
without pitch change. You can also use this dial to increase
and decrease the numeric values or input alphabetical
characters in edit mode.
Rotating the JOG dial while holding down the SHIFT key
will enable you to perform the shuttle operation with
different speeds ranging from normal speed to 64-times
speed.
Refer to page 57 for more information on the cue/review
function and the shuttle function.
Copy Clip
Move Clip
Copy Paste (or Move Paste *)
Erase
TRK Exchange
12. Edit key [EDIT]
Pressing this key enters the VR800 to the menu select mode
for editing tracks, and displays the title of the menu you
used last time. Press this key repeatedly or turn the JOG
dial to select a menu. The edit menus appear in the following
order. To execute a desired menu, select the menu, then
press the EXECUTE/YES key.
To exit selection mode, press the EXIT/NO key.
(*) After you execute copy clip, “Copy Paste” appears. After you execute
move clip, “Move Paste” appears.
* Refer to page 61 for more information on Copy & Paste
and Move & Paste.
* Refer to page 64 for more information on Erase.
* Refer to page 66 for more information on Track Exchange.
14. Scrub key [SCRUB]
Pressing this key causes its lamp to light up as the VR800
will enter the digital scrub mode. At this point, press the
desired RECORD TRACK select key to digitally scrub the
selected track playback using the JOG dial.
Refer to page 58 for more information on Digital Scrub mode.
* Refer to page 54 for more information on the Locate
function.
* Refer to page 51 for more information on editing data
using the LOCATE key.
16. Locate key [LOCATE/ LOC MEM ]
Use this key to start the LOCATE feature.
Pressing this key after a memory key (CLIPBOARD IN/OUT,
AUTO RTN START/END, AUTO PUNCH IN/OUT) locates the
memory data programmed in each respective key (time
mode or bar, beat, clock setting).
The data can be programmed by individually setting it with
one of the 99 (01-99) locate numbers of the LOCATE key.
Note that the data of locate number 00 is available in
addition to locate numbers 01-99. The last locate time setting
(bar, beat, clock setting) constantly replaces the data stored
in the LOCATE key as data in locate number 00. Therefore,
it is possible to press this key alone to repeatedly locate the
same point.
Pressing the LOCATE key while holding down the SHIFT key
will cause the VR800 to enter edit mode, in which you can
edit data stored in the LOCATE key.
AUTO
RTN
AUTO
PLAY
PLAY
AUTO
RTN
AUTO
Auto Repeat mode is ON.
(Both “PLAY” and “RTN” light up.)
Auto Return/Play mode is OFF.
(No indication)
Auto Play mode is ON.
(“PLAY” lights up.)
Auto Return mode is ON.
(“RTN” lights up.)
17.Auto Return/Auto Play mode on/off key
[AUTO RTN/AUTO PLAY]
Use this key to turn on and off auto return mode, auto play
mode, and auto repeat mode. Each time you press the key,
the mode will change and the following indication displayed.
* Auto Play mode
The VR800 locates a point and starts playing from the locate point.