Fostex VR800 - Manual (Page 53)

VR800 Owner’s Manual (Storing a Locate Point <Edit Point>)
53
Edit and re-store data that is already stored
RECALL the desired time data already stored in the LOCATE key, edit that data and re-store it.
1. Press the LOCATE key, while holding down the
SHIFT key, while the VR800 is stopped.
The menu to select the LOCATE number will appear.
2. Turn the JOG dial to select the desired LOCATE
number, then press the LOCATE key.
The data edit mode will appear when the data stored in
the selected LOCATE number appears.
•If the STORE key is press instead of the LOCATE key at
this stage, it becomes possible to directly LOCATE the
time data of the selected LOCATE number. For more
details refer to the next section on “Location Functions.”
5. You can use the JOG dial to input the desired
LOCATE number.
6. Press the LOCATE key.
The edit time data is stored as the time data for the
selected LOCATE number.
5. Press the LOCATE key.
The edit time data is stored as the time data for the
selected LOCATE number.
4. Select the LOCATE number desired using the JOG
dial.
2. Press the HOLD/> key, REWIND button, or the F FWD
button to move the flashing cursor on the time value
digit, and use the JOG dial to increase or decrease
the value.
3. Press the STORE key. (the STORE key lamp lights up.)
2, 4
3 1, 2
SHIFT P.EDIT LOC MEM
RECORD STOP PLAY REW F FWD
AUTO PUNCH
CLIPBOARD AUTO RTN
OUT IN END OUT IN START
EJECT
ACCESS
5 6 7 8
OL
24
12
6
0
1 2 3 4
RECORD TRACK
4 3 2 1 5 6 7 8
EXECUTE / YES EXIT
/ NO
DISP SEL UNDO / REDO EDIT HOLD/ STORE SETUP
JOG VARI PITCH SCRUB LOCATE AUTO PLAY
PGM SEL
AUTO RTN TIME BASE SEL SHUTTLE
LOCATE REC END LOCATE ABS 0 CLIPBOARD PLAY PUNCH AUTO
OPTICAL
A SYNC
PREVIEW
2
5
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
LOC S M F SF
DIGITAL
ABS
44.1kHz
Flashing
Flashing
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
DIGITAL 44.1kHz