Fostex VR800 - Manual (Page 89)

89
VR800 Owner’s Manual (Changing the initial setting: SETUP mode)
“Sign. Set ?” menu
“Tempo Set ?” menu
“Title Edit ?” menu
“Del PGM ?” menu
“Click ?” menu
“Preroll ?” menu
“Sync Out ?” menu
“Frame Rate ?” menu
“Mtc Offset ?” menu
“Ofset Mode ?” menu
“Slave Mode?” menu
“Slave Type?” menu
“Rec Protect ?” menu
“Digi. in ?” menu
“Digi. out ?” menu
“ Resolu ?” menu
“Device ID ?” menu
“NOs Event ?” menu “Save PGM ?” menu
“Format ?” menu
“Bk Format ?” menu
“Load PGM ?” menu
The following diagram shows the position of each menu.
Selecting SETUP mode
Follow the steps below to select the desired SETUP menu in SETUP mode.
This indicates the position of the SETUP menu. Selecting a
menu via the JOG dial will move the flashing cursor.
The title of the SETUP menu
appears. You can select a different
menu via the JOG dial. This lights up when the VR800
enters SETUP mode.
Note: With the factory initial settings, or when you turn on the
power again after you format an external SCSI disk, “Sign. Set?
(Setting a time signature)” appears. Otherwise, the first hierarchy
level of the previously-selected SETUP menu appears.
1. While the VR800 is stopped, press the SETUP key
on the control panel.
Pressing the SETUP key causes the VR800 to enter SETUP
mode. The VR800 displays the first hierarchy level of
the SETUP menu you selected before you turned off the
power. At this time, the menu graphics appear as shown
below.
The flashing menu indicator is the currently-selected
menu. Turning the JOG dial will select a different menu
and the corresponding menu indicator will flash.
2. Select the desired menu using the JOG dial, then
press the EXECUTE/YES key.
The VR800 displays the second hierarchy level of the
selected SETUP menu, where you can set parameters.
(Refer to the next page for more information.)
To exit SETUP mode, press the STOP button or the EXIT/
NO key. Each time you press one of these keys, the VR800
returns to the previous hierarchy level of the menu, and
finally exits SETUP mode.
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz DIGITAL