Fostex VR800 - Manual (Page 33)

33
VR800 Owner’s Manual (Handling Programs)
SHIFT P.EDIT LOC MEM
RECORD STOP PLAY REW F FWD
AUTO PUNCH
CLIPBOARD AUTO RTN
OUT IN END OUT IN START
EJECT
ACCESS
5 6 7 8
OL
24
12 6
0
1 2 3 4
RECORD TRACK
4 3 2 1 5 6 7 8
EXECUTE / YES EXIT
/ NO
DISP SEL UNDO / REDO EDIT HOLD/ STORE SETUP
JOG VARI PITCH SCRUB LOCATE AUTO PLAY
PGM SEL
AUTO RTN TIME BASE SEL SHUTTLE
LOCATE REC END LOCATE ABS 0 CLIPBOARD PLAY PUNCH AUTO
OPTICAL
A SYNC
PREVIEW
PGM 01 PGM 02 PGM 03 PGM 04 PGM 05 PGM 06 PGM 07 New PGM
You can select from PGM 03 up to
New PGM in this direction.
You can select up to PGM
01 in this direction.
2
3
1
7. When you finish entering the title, press the
EXECUTE/YES key.
Program 2 (PGM 02) and its title are set.
The display shows the ABS time base indication of the
program.
<Important!>
• Whenever you create a new program by selecting the [New PGM
?] menu, a new program is created with an increment number.
That is, if only one program exists, the next one will be named
program 2.
If programs 1-5 already exist, the new program number will be 6.
• If there is insufficient recording space on the disk, you cannot
create the new program. Each time you create a new program,
the recordable area on the disk will decrease.
Using a Program Change function
If multiple programs exist on the disk, you need to select a program to record, play, or edit. This section
describes how to select a program.
Note: You cannot use the program change function if the VR800
is in SETUP mode.
2. Turn the JOG dial to select the desired program
number (flashing).
Rotating the JOG dial counter-clockwise decreases the
number. Rotating it clockwise increases the number.
If you turn the JOG dial clockwise all the way, [New PGM?]
will be selected. Select [New PGM ?] to create a new
program as mentioned in the previous section.
For example, you can select one of seven programs as
follows:
3. Press the EXECUTE/YES key.
The ABS time base indication for the selected program
appears. In this way, you can be sure to select a program
before you start working.
To enter a title:
• Turning the JOG dial will enter a character or number
at the location of the flashing cursor. You can enter
up to 16 characters, nine of which will appear on the
display.
• To move the flashing cursor, press the HOLD/> key,
the REWIND button, or the F FWD button. The F FWD
button is the most convenient.
• You can enter the following characters and numbers:
1. When the VR800 is stopped, press the STORE key
while holding down the HOLD/> key.
[Select PGM] will appear on the display briefly, and then
change to a flashing “01” ([#0001 of PGM 01) and [SURE?]
flash. ([#0001] is the default name of PGM 01.)
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
SURE ?
DIGITAL 44.1kHz