Fostex VR800 - Manual (Page 41)

41
VR800 Owner’s Manual (Punch In/Out Recording)
Track 5
Track 6
Track 7
Track 8
Punch In point
(Rehearsal In) Punch Out point
(Rehearsal Out)
Track 1
Track 2
Track 3
Track 4
This part is changed.
Playback
start point
Playback
end point
All tracks are in playback
monitoring mode.
Only track 3 in input
monitoring.
The sound is not recorded at
this time.
The RECORD button lamp
flashes.
All tracks are in playback
monitoring mode.
Press the foot switch at the
Punch In point.
Press the foot switch at the
Punch Out point.
1. Confirm that Rehearsal mode is cancelled, and start
playing the VR800 from a point slightly before the
desired Punch In point.
2. Play the guitar, accompanying the playback of
tracks 1 to 8.
3. Press the foot switch at the desired Punch In point.
Press the foot switch again at the desired Punch
Out point.
The VR800 will operate as follows. The VR800 enters
recording mode at the Punch In point, and cancels
recording mode at the Punch Out point.
4. Press the STOP button.
5. Play track 3 and check the result of Punch In/Out.
<Caution after Punch Out>
At “Take” of punch out, the punch-in recording track will not
immediately enter the repro monitor mode from the input
monitor mode enter the repro monitor mode about two
seconds after mute playback. This is a functional feature of
VR800 and not a malfunction.
Track 5
Track 6
Track 7
Track 8
Punch In point
(Take In)
Punch Out point
(Take Out)
Track 1
Track 2
Track 3
Track 4
This part is changed.
Playback
start point
Playback
end point
All tracks are in playback
monitoring mode.
Only track 3 in input
monitoring, and data will be
recorded.
The RECORD button lamp
lights up in this area.
All tracks are in playback
monitoring mode.
Press the foot switch at the
Punch In point.
Press the foot switch at the
Punch Out point.
6. When you finish rehearsing, press the STOP button.
If you are still unsatisfied, repeat steps 3-5.
Cancelling Rehearsal mode
1. While holding down the STOP button, press the foot
switch.
[Rehsl Off] appears for a second, the flashing [RHSL]
indicator in the A.PUNCH display area disappears, and
Rehearsal mode is cancelled.
<Hint>
To rehearse repeatedly, set the AUTO RTN START point slightly
before the Punch In point, and the AUTO RTN END point slightly
before the Punch Out point.
This will help you concentrate on your performance or check the
recording level easily (especially since Manual Punch In/Out
involves operating the foot switch operation as well as the
VR800). (See <Hint-2> in the “Rehearsing Auto Punch In/Out
recording” for more information.)
Manual Punch In/Out take
You can proceed to record if you are satisfied with the recording level, foot switch timing, and rehearsal.
Note:
You cannot record a second take during the Manual Punch
In/Out operation without stopping the VR800. That is, the VR800
will continue playing after you finish recording a take, but you cannot
record another take by pressing the foot switch.