Fostex VR800 - Manual (Page 94)

94
VR800 Owner’s Manual (Changing the initial setting: SETUP mode)
Locate point (stored in the memory key) This point is actually located.
This point is located if the current position is before
the locate point.
This point is located if the current position is after the locate point.
3. Turn the JOG dial to select [on] or [oFF].
Selecting [on] will enable the output of the metronome
sound. Selecting [oFF] (initial setting) will disable the
metronome output.
4. Press the EXECUTE/YES key.
The display shows the selection (on or oFF), then returns
to the indication in step 2.
To cancel the setting operation, or to restore a setting
obtained prior to the EXECUTE/YES key press, press the
STOP button or the EXIT/NO key. Each time you press
one of these keys, the VR800 returns to the previous
hierarchy level of the menu, and finally exits SETUP mode
and displays the previous Time Base.
Setting a preroll value (“Preroll ?” menu)
The VR800 features the Preroll function that enables you to locate a position a few seconds prior to a specified
locate point. The “Setting a preroll value” menu allows you to set the preroll time (in seconds).
The Preroll function is convenient when you wish to monitor the audio data from a point slightly before the
locate point.
• Initial setting : [00] second
• Setting range of preroll time : [00]-[10] seconds in one second steps
* You can set the value for each Program individually.
* The settings can be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the unit.
Preroll time (before the locate point) can be set between 00 and 10 seconds.
Setting a preroll time
1. While the VR800 is stopped, press the SETUP key
to enter SETUP mode.
2. Turn the JOG dial to select [Preroll ?] ([?] flashes.),
then press the EXECUTE/YES key.
The current preroll time setting appears on the display.
Pressing the EXECUTE/YES key lights up the flashing [?]
character steadily; the current setting flashes. The initial
setting is [00] as shown below.
3. Turn the JOG dial to enter a desired preroll time
value.
You can set a value in one-second increments.
Rotating the JOG dial clockwise increases the value, and
rotating it counter-clockwise decreases the value.
4. Press the EXECUTE/YES key.
The display shows the value, then returns to the
indication that appeared in step 2.
To cancel the setting operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press the
STOP button or the EXIT/NO key. Each time you press
one of these keys, the VR800 returns to the previous
hierarchy level of the menu, and finally exits SETUP mode
and displays the previous Time Base. SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
S
44.1kHz DIGITAL
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
S
44.1kHz DIGITAL
flashes
flashes