Fostex VR800 - Manual (Page 104)

104
VR800 Owner’s Manual (Changing the initial setting: SETUP mode)
3. Use the JOG dial to turn the mode [on] or [off].
When you turn the JOG dial clockwise and counter-
clockwise, [on] and [o FF] flash alternately.
Selecting [on] turns BAR/BEAT resolution mode on, and
selecting [o FF] turns BAR/BEAT resolution mode off.
4. Press the EXECUTE/YES key.
The selected mode setting is stored, and [?] flashes.
To cancel the operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press
the STOP button or the EXIT/NO key. Each time you
press one of these keys, the VR800 returns to the
previous hierarchy level of the menu, and finally exits
SETUP mode and displays the previous Time Base.
Setting the MIDI device number (“Device ID ?” menu)
The “Setting the MIDI device number” menu enables you to set the VR800 device ID number required to control
the unit from a sequence software using MMC (MIDI Machine Control) or FEX (Fostex System Exclusive Message).
The transmit device ID links to this setting. You can set the device ID from 00 to 99.
However, if the device ID number of the message the VR800 receives is [7F], the VR800 will recognizes it to
perform the corresponding operation, regardless of its device ID setting.
• Initial setting : [00]
• Device ID : [00] ~ [99]
* This setting is shared by all Programs in the same disk.
* The settings cannot be saved and loaded as part of the song data.
* The settings are maintained after you turn off the power to the unit.
Setting the MIDI device ID
1. While the VR800 is stopped, press the SETUP key
to enter SETUP mode.
2. Turn the JOG dial to select [Device ID?] ([?] flashes),
then press the EXECUTE/YES key.
The current MIDI device ID number appears on the
display. Pressing the EXECUTE/YES key turns off the
flashing [?] character, and the MIDI device ID number
flashes. With the initial setting, [00] flashes as shown
below.
3. Use the JOG dial to set the desired MIDI device ID
number.
Turning the JOG dial clockwise increments the value, and
turning it counter-clockwise decrements the value.
To cancel the operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press
the STOP button or the EXIT/NO key. Each time you
press one of these keys, the VR800 returns to the
previous hierarchy level of the menu, and finally exits
SETUP mode and displays the previous Time Base.
4. Press the EXECUTE/YES key.
The MIDI device ID number is stored, and [?] flashes.
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz DIGITAL
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz DIGITAL
flashes
flashes