Fostex VR800 - Manual (Page 105)

105
VR800 Owner’s Manual (Changing the initial setting: SETUP mode)
Indicating the track number. Indicating the number of
selected track events
Checking the number of track events
1. While the VR800 is stopped, press the SETUP key
to enter SETUP mode.
2. Turn the JOG dial to select [NOs Event?] ([?]
flashes), and then press the EXECUTE/YES key.
The screen changes as follows, indicating the number of
events on track 1. (In this example, track 1 includes eight
events.)
3. Use the JOG dial to select another (01-24) to check
the number of events on the corresponding track.
4. Press the EXIT/NO key or the STOP button
repeatedly to exit SETUP mode.
To cancel the operation, or to restore the setting
obtained prior to the EXECUTE/YES key press, press
the STOP button or the EXIT/NO key. Each time you
press one of these keys, the VR800 returns to the
previous hierarchy level of the menu, and finally exits
SETUP mode and displays the previous Time Base.
* For more information on audio files and events, refer to
the “Audio file and event” section of the ”Before Starting”
chapter.
Checking the number of track events (“NOs Event ?” menu)
The “Checking the number of track events” menu enables you to check the number of events on each track.
Each track (including Additional tracks) of VR800 Programs consists of consecutive audio files (and “zero” files).
The number of events represents the total number of audio files and 0 files. Each track can contain up to 512
events.
If you are editing a song of typical length (about six minutes), repeated editing operation does not usually cause
this maximum number to be exceeded. (Exceeding this limit is called “event number overflow.”) Even a 20-
minute song will not cause event number overflow. This is because the VR800 system always optimizes the data
structure by keeping the number of events low. However, if a recording on a track is scattered in different areas
of the disk, or if you have made a very long recording on a single track and performed many edits, you should be
wary of “event number overflow.” To avoid this problem, use the “Checking the number of track events” menu
to check the number of events on each track prior to recording or editing.
flashes
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
SETUP
44.1kHz DIGITAL
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
SETUP
44.1kHz DIGITAL
CLK
SYNC OUT DRIVE
SCSI
AUTO A.PUNCH
SETUP
44.1kHz DIGITAL