FMI PFS P324E - Manual (Page 11)

www.fmiproducts.com 108794-01G 11
FIrePlACe INstAllAtIoN
Figure 12 - Removing Front Refractory
Access Panel (P325E/VP325E Model
Shown)
Figure 13 - Installing the WRC Remote
Receiver
Fireplace
Receptacle
Remote
Control
Receiver
Extension
Cord
Ignition Module
Plug
Figure 14 - Installing Battery into Back of
Handset
Pull to Remove
Insulation Tab
Battery Cover
12 Volt Battery
Back of
Handset
WALL SWITCH INSTALLATION
The installation of a wall switch allows you
to activate the gas control valve and turn the
fireplace on and off. The wall switch is to be
connected to the incoming 120 volt regular
household wiring that supplies the electricity
to the fireplace. Refer to Wiring Diagram,
page 21.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)
Note: If using optional wireless hand-held
remote control, wall switch must be in ON
position to be operational. The remote control
then becomes the switching mechanism for
fireplace operation.
1. Remove front refractory access panel by
lifting up and angling out of firebox open-
ing (see Figure 12).
2. WRC model receiver does not require a
battery. Receiver can be installed by first
plugging short extension cord into fireplace
receptacle. Plug receiver unit into exten-
sion cord. Finally, plug ignition module plug
into receiver unit (see Figure 13).
3. Activate remote handset battery by re-
moving insulating tab on back of handset
(see Figure 14). Battery is included pre-
installed.
4. Once battery is activated, unit is ready to
use.
5. Replace front refractory access panel.