FMI PFS P324E - Manual (Page 19)

www.fmiproducts.com 108794-01G 19
TO TURN OFF GAS
TO APPLIANCE
1. Turn off wall switch.
2. Turn off all electric power to appliance if
service is to be performed.
3. Fully open glass doors if installed.
4. Remove front hearth brick and control
access panel.
oPerAtIoN
Continued
Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame. Alterations may have occurred
during shipping and handling. The pilot is lo-
cated on the back right hand side of burner.
The flame must envelope 1/4" of top of the
ignitor/sensor and grounding stem.
If your pilot assembly does not meet these
requirements:
• Turn adjustment screw marked PILOT
clockwise to decrease or counterclockwise
to increase flame to proper size (see Figure
36). Do not remove adjustment screw.
• see Troubleshooting, page 22
5. Turn equipment shutoff valve clockwise
to the OFF position. Do not force.
6. Replace front refractory brick access
panel.
7. Fully close glass doors if installed.
OPTIONAL REMOTE
OPERATION
Note: The WRC receiver and hand-held re-
mote control kit must be purchased separately
(see Accessories, page 25). Follow installa-
tion instructions on page 11.
Turn equipment shutoff valve to the ON posi-
tion. You can now turn the burner on and off
with the hand-held remote control unit.
IMPORTANT: Be sure to press the ON/OFF
buttons on the hand-held remote control unit for
up to 3 seconds to assure proper operation.
Figure 35 - Pilot
Sensing
Rod
Pilot
Burner
Ignitor
Pilot
Burner
Ignitor/
Sensor
Figure 36 - Correct Pilot Flame Pattern
Sensing
Rod
BURNER FLAME PATTERN
Burner flames will be steady, not lifting or float-
ing. Flames should go up through the middle
of log set. Flames should not "spill" to edges
of pan or sides of log set.
Figure 37 shows a typical flame pattern. If burn-
er flame pattern differs from that described:
• turn appliance off (see To Turn Off Gas to
Appliance, above)
• see Troubleshooting, page 22
Figure 37 - Typical Flame Pattern
P325E(B) and VP325E(B) Models
P324E and VP324E Models
INsPeCtING BurNers