FUJITSU SPARC T5440 - Manual (Page 127)

Servicing Customer-Replaceable Units 101
2. Slide the module down into its slot.
FIGURE: Installing a CMP/Memory Module
3. Rotate the ejector levers down to secure the module into place.
Next Steps
■ “Install the Top Cover” on page 150
■ “Slide the Server Into the Rack” on page 151
■ “Power On the Server” on page 153
▼ Add a CMP/Memory Module
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 59 .
■ Power off the server, using one of the methods described in the section, “Powering
Off the System” on page 63 .
■ “Extend the Server to the Maintenance Position” on page 66
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 69
■ “Remove the Top Cover” on page 69
Do the following :
1. Identify the correct slot for installation.