GE DSR-1000eZ - Manual (Page 10)

Calibur DSR-1000eZ 1-4 0150-0238A
Video Out: Composite video output with BNC style connector.
Ethernet Port (Ethernet models only)
Wire Type: CAT5
Connector Type: RJ-45
Max Cable Length: 100 feet / 30.5 meters
Minimum Cable Length: 6 feet / 1.8 meters
Hub Wiring Configuration: Straight Through
PC Wiring Configuration: Cross Over
The cable connection configuration depends on your
network configuration:
•
For a DSR-1000eZ that connects directly to a
Hub, use a Straight Through connection.
•
For a DSR-1000eZ that connects directly to a
PC, use a Cross Over connection.
Consult with your MIS personnel for the specific type
of configuration. See section 5.5 Advanced Menu
→
Communications for information about configuring
the ethernet settings in the menu system.
RJ-45 Pin Configuration for Ethernet Port
Pin Use Pin Use
1 TX+ 5 Not Connected
2 TX- 6 RX-
3 RX+ 7 Not Connected
4 Not Connected 8 Not Connected
8 2 3 4 5 6 7 1
RJ-45 Connector on
Back Panel
Power Connector
Power Supply Input Power Supply Output
Voltage: 120 to 240 Volt AC
Tolerance: ±10%
Frequency: 50 to 60 Hz
Voltage: 12 Volt DC
Power: 35 Watt
Connector: 2.1mm barrel, Center
Positive
SCSI Port
Connector: 50 Pin, High Density SCSI-2.
Gender (on unit): Female
Compatible devices: DAT, AIT, CD-R, CD-RW
Autoloader Support?: No
SCSI ID: 0
The unit is equipped with a SCSI port for
connecting external archive devices. The unit only
supports a single SCSI device. The SCSI ID must
be set to 0.
The SCSI bus must be terminated, otherwise the
system will not operate properly.
Additional menu setup may be necessary to
configure archive device. See section 4.6
Main
Menu
→
Archive Setup.