GE DSR-1000eZ - Manual (Page 20)

Calibur DSR-1000eZ 2-4 0150-0238A
Search Filters
Start
DATE: 12/25/00 [ ]
(MM/DD/YY)
Stop
01/01/01 [ ]
(MM/DD/YY)
Start
TIME: 11:11:21 [ ]
Stop
12:34:34 [ ]
1 2 3 4 5 6 7 8
CAMERA: [ ][ ][ ][ ][ ][ ][ ][ ]
ALARM: [ ]
Use this to specify:
•
The Start and Stop date of
the search.
•
The Start and Stop time of
the search.
•
Which cameras to search
exclusively.
•
To search for recorded
alarms.
[CANCEL] [START SEARCH]
Searching for All Recorded Events
Using the Shuttle to navigate, highlight [START SEARCH], then press the Enter button. The Search
Results window will appear. For information about selecting a recorded event, see Selecting from
the Search Results, in this section.
2.4 Specifying Search Parameters
Selecting a Start and Stop Date
1. Using the Shuttle to navigate, highlight the DATE parameter, then press the Enter button. The
unit will enter Edit mode.
2. Use the Jog to change the start and stop date values. Use the Shuttle to navigate among the
different parameters.
3. To activate the start or stop date parameter, use the Jog to place an [X] in the check box.
4. Press the Enter button at any time to exit Edit mode.
Selecting a Start and Stop Time
1. Using the Shuttle to navigate, highlight the TIME parameter, then press the Enter button. The
unit will enter Edit mode.
2. Use the Jog to change the start and stop time values. Use the Shuttle to navigate among the
different parameters.
3. To activate the start or stop time parameter, use the Jog to place an [X] in the check box.
4. Press the Enter button at any time to exit Edit mode.
Selecting Cameras to Search
1. Using the Shuttle to navigate, highlight the CAMERA parameter, then press the Enter button. The
unit will enter Edit mode.
2. Use the Shuttle to navigate among the different cameras.
3. Use the Jog to select a camera (or cameras) by placing an [X] in the check box.
4. Press the Enter button at any time to exit Edit mode.