GE EPM 5200 - Manual (Page 59)

CHAPTER 9: PROGRAMMING GROUP 0 – GLOBAL METER SETUP
GE Multilin EPM 5000 series Advanced Power Meters 55
9.9: Group 0, Function 6—KYZ Parameter Selection
NOTE: FUNCTION 6 applies only if Option -NL or -NL2 was ordered.
OPTION -NL: This option gives the meter 2 Relays and one KYZ pulse. The KYZ pulse can be
programmed to the below features.
Select a single parameter from Table 9-5 according to the EPM 5300P model being programmed.
OPTION -NL2: This option offers 3 distinct KYZ pulses instead of Relays.
Only three separate parameters may be selected: FUNCTION 6.0 (KYZ Port 0), FUNCTION 6.1 (KYZ
Port 1), and FUNCTION 6.2 (KYZ Port 2). The available parameters vary according to the EPM 5300P
model being programmed. For exact port positions see Installation Sections.
PARAMETER DESCRIPTION
0 Disable KYZ
1 Positive Watt Hour KYZ
2 VA Hour KYZ
3 Negative Watt Hour KYZ
4 Positive VAR Hour KYZ
5 Negative VAR Hour KYZ
Table 9-5: KYZ Parameters
APPLICABLE SELECTIONS: 5300P - +WH, -WH, VAH
5300P+R* - +WH, -WH, +VARH, -VARH
* (-R option gives the 5300P VAR/Hour readings instead or VA/Hours).
To perform the KYZ Parameter Selection:
NOTE: Press MAX/MIN/LIMITS at any time to cancel before storing the last digit or switch.
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ KWH KVAH
AC VOLTS
AC AMPS
POWER
N C B A
MAX
MIN A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE VOLTS AMPS POWER
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ KWH KVAH
AC VOLTS
AC AMPS
POWER
N C B A
MAX
MIN A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE VOLTS AMPS POWER
Step 1:
a. Enter Group Level of Programming Mode
(see Chp. 8).
b. Press MAX/MIN/LIMITS until 0. appears in
upper display.
c. Press AMPS to activate the Group.
Step 2:
a. Press MAX/MIN/LIMITS until 06.P appears in
upper display.
(Standard Selection is 1).