Gateway DVD Player - Manual (Page 28)

22 www.gateway.com
3
If the player’s network card is a wired Ethernet card, connect one end of an Ethernet
cable to the network card, then connect the other end to an Ethernet jack on your
existing network.
4
After you connect video and audio cables and install the network card, configure your
video by following the instructions in
“Turning on your player” on page 22 .
Turning on your player
To turn on your player:
1
Make sure that your computer is on and running Media Server, your home network
is set up, and all audio and video devices are turned on.
2
Connect the player’s power cord to a wall outlet, then press the POWER button on
the front of the player. The LED in the POWER button turns green.
3
Turn on your TV.
4
Turn on any video device the DVD player is connected to, then use the video device’s
controls to set it to the audio/video input type connected to the player.
5
Turn on any audio device the DVD player is connected to, then use the audio device’s
controls to set it to the audio input type connected to the player.