Gateway DVD Player - Manual (Page 48)

42 www.gateway.com
Setting the IP address
While connecting to a network, networked devices are assigned a unique identifier known
as an IP address. IP addresses are used to direct network traffic to the correct destination.
An IP address is usually displayed as numbers separated by periods, such as 192.168.0.2.
To change the way the IP address is assigned:
1
On the player’s remote control, press STOP , then press SETUP . The Welcome to Setup
screen opens.
2
Highlight Network , then press ENTER .
3
Highlight Get IP Address .
4
Press the buttons to choose one of the following:
■ DHCP (Auto) — Automatically assigns an IP address and provides other
configuration information (recommended).
■ Auto IP — Lets the player obtain an IP address for itself.
■ Static (Press Enter to Edit) — Lets you set the IP address and Subnet Mask.
Important DHCP (Dynamic Host Configuration Protocol) is an Internet protocol
for automatically configuring computers that use TCP/IP. DHCP can
be used to automatically assign IP addresses and to provide other
configuration information.
Important Static IP addresses are numeric addresses that you assign to
uniquely identify your network devices. Only experienced network
users should manually set the IP address.
If you select Static (Press Enter to Edit) , press Enter , then manually
enter the IP address and Subnet Mask with the 0 through 9 buttons.
Highlight
OK , then press ENTER to save and exit.