List of commands in this chapter, Igure, Participating in s-ring – GarrettCom MNS-6K 4.1.4 User Manual

Page 186

Advertising
background image

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E

Link-Loss-Learn Enabled.

Magnum6K25(stp)##

lll add port=1,2,3

Added Ports: 1,2,3

Magnum6K25(stp)##

show lll

Link-Loss-Learn Status:

LLL Status: ENABLED
LLL Enabled on Ports: 1,2,3

Magnum6K25(stp)##

lll del port=2,3

Deleted Ports: 2,3

Magnum6K25(stp)##

lll disable

Link-Loss-Learn Disabled.


F

IGURE

97 – Link Loss Learn (LLL) setup. Setup LLL on ports connected to other switches

participating in S-Ring

List of commands in this chapter

Syntax authorize <module> key=<security key> - activate the S-Ring capabilities. Don’t forget

to use the “save” command to save the key


Syntax
stp – STP Configuration mode

Syntax stp <enable|disable> - Start (Enable) or stop (Disable) STP

Syntax
set stp type=<stp|rstp> - set the spanning tree protocol to be IEEE 802.1d or 802.1w

(Spanning Tree Protocol or Rapid Spanning Tree Protocol)


Syntax
show active-stp – Display which version of STP is currently active

Syntax
show s-ring – show the status of S-Ring status and configuration

Syntax
s-ring <enable|disable> - enable or disable S-Ring capabilities

Syntax s-ring learnstart the learning process to discover the ring and the ports which make up the S-

Ring


Syntax s-ring add port=<port1,port2> - define ports which make up the S-ring ports. Note as

discussed earlier, you can create multiple S-Rings on a switch


Syntax s-ring del port=<port1,port2> - remove the switch from S-Ring topology by eliminating the

end ports on the switch


Syntax lll <enable|disable> - enable or disable LLL on the switch

185

Advertising
This manual is related to the following products: