GarrettCom MNS-6K 4.1.4 - Manual (Page 305)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Command Description
add port=<number|list|range>
[priority=<0-65535>]
add the specified list of ports to form the logical
LACP trunk. Default value for priority is
32768. The lower the value assigned to priority,
the higher the priority. The port with the highest
priority is the primary port (over which certain
types of traffic like IGMP is transmitted).
Requires the lacp command (module).
addlease ip=<ip> mac=<mac>
[leasetime=<lease time (1..10)>] add a specific host with a specific IP address
alarm enter the alarm configuration mode
alarm <enable|disable> globally enables or disables the alarm action
alarm def-owner=<string> def-
comm=<string> define the RMON alarm group and the
community string associated with the group
allow ip=<ipaddress>
mask=<netmask> service=<name|list> allow specific IP address or range of addresses as
a trusted host(s)
allow mac=<address|list|range>
port=<num|list|range> specify a specific MAC address or MAC
address list
auth configuration mode to configure the 802.1x
parameters
auth <enable|disable> enables or disables the 802.1x authenticator
function on MNS-6K switch
authorize <module> key=<security
key>
activate the S-Ring or MNS-6K-SECURE
capabilities. Don’t forget to use the “save”
command to save the key
authserver [ip=<ip-addr>]
[udp=<num>] [secret=<string>] define the RADIUS server
authtraps <enable|disable> enables or disables authentication traps
generation
backend port=<num|list|range>
supptimeout=<1-240>]
[servertimeout=<1-240>] [maxreq=<1-
10>] configure parameters for EAP over RADIUS
backpressure rxthreshold=<value> configure backpressure buffers
broadcast-protect <enable|disable> protect switch from broadcast storms
chlevel user=<name> level=<number> changing the user privilege level
304