GarrettCom MNS-6K 4.1.4 - Manual (Page 293)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax start vlan=<name|number|list|range> activate the VLAN configuration
Syntax save save the configuration (including the VLAN configuration)
Syntax edit id=<vlan id> [name=<vlan name>] port=<number|list|range>
[<mgt|nomgt>] - edit existing VLAN name
Syntax show vlan [<id=vlanid>] display specific VLAN information
Syntax set-port port=<number|list|range> default id=<number> sets the default VLAN id.
For Magnum 6K family of switches, the default VLAN id is 1, unless changed using this command
Syntax set-port port=<number|list|range> filter status=<enable|disable> enables or disables
the VLAN filtering function.
Syntax set-port port=<number|list|range> tagging id=<number> status=<tagged|
untagged> defines whether the outgoing packets from a port will be tagged or untagged.
Syntax set-port port=<number|list|range> join id=<number> adds the specified port(s) to the
specified VLAN id
Syntax set-port port=<number|list|range> leave id=<number> releases a specific port from a
VLAN
Syntax show-port [port=<port|list|range>] shows all parameters related to tag vlan for the list of ports.
If the port parameter is omitted, it will display all ports
Chapter 12 – Spanning Tree
Protocol (STP)
Syntax show stp <config|ports > - regardless of whether STP is enabled or disabled (default) this
command lists the switch’s full STP configuration, including general settings and port settings
Syntax stp – STP Configuration mode
Syntax stp <enable|disable> - Start (Enable) or stop (Disable) STP
Syntax priority [port=<number|list|range>] value=<0-255 | 0-65535> - specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports and their value is 0-
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
Syntax cost port=<number|list|range> value=<0-65535> - cost is specific to a port and the port(s)
have to be specified
292