GarrettCom MNS-6K 4.1.4 - Manual (Page 309)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Command Description
group <add|delete> id=<id>
[groupname=<name>]
[model=<v1|v2c|usm>]
[com2secid=<com2sec-id>] a part of the View based Access control model
(VACM) as defined in RFC 2275. This
command defines the mapping from sec model or
a sec name to a group. A sec model is one of v1,
v2c, or usm. On MNS-6K, up to 10 entries can
be specified
group add ip=<group ip>
port=<number|list|range>
vlan=<vlanid>
group del ip=<group ip>
add ports to a specific IGMP broadcast. This
commands is part of the IGMP commands
delete ports from a specific IGMP broadcast
group
gvrp <enable|disable> enable or disable GVRP
host <add|edit|del> name=<host-name>
[ip=<ipaddress>] [user=<user>]
[pass=<password>]
create a host entry for accessing host.
This is equivalent to creating a host
table on many systems. Maximum of 10
such entries are allowed
help <command string> help for a specific command
history def-owner=<string> def-
comm=<string> define the RMON history group and the
community string associated with the group
igmp IGMP configuration mode
igmp <enable/disable> enable or disable IGMP on the switch
ipconfig [ip=<ip-address>]
[mask=<subnet-mask>]
[dgw=<gateway>] to set IP address on the switch
kill config [save=system] resets the system configuration. The
module_name option does not reset the specific
module parameters. The modules are system,
event, port, bridge, stp, ps, mirror, sntp, vlan,
gvrp and snmp
kill session id=<session> terminate a telnet session. See also “show session”
lacp
enable the LACP configuration module within
CLI
lacp <enable | disable>
enable or disable LACP
learn port=<number-list>
<enable|disable> learn MAC addresses connected to the
Magnum 6K switch
308