GarrettCom MNS-6K 4.1.4 - Manual (Page 287)

M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax show sysconfig – reviews settable system parameters
Syntax show time – shows the system time
Syntax show timezone – shows the system timezone
Syntax show date – shows the system date
Syntax show uptime – shows the amount of time the switch has been operational
Syntax show config [module=<module-name>] – displays the configuration
Syntax set secrets <hide|show> - sets the system parameter to display or hide the passwords
Syntax kill config [save=module-name] – resets the system configuration. The module-name option does
not reset the specific module parameters. The modules are listed below
Chapter 4 – IPv6
Syntax ipconfig [ip=<ip-address>] [mask=<subnet-mask>] [dgw=<gateway>]
[add|del] – configure and IPv6 address. The add/delete option can be used to add or delete
IPv4/IPv6 addresses
Syntax show ipconfig – display the IP configuration information – including IPv6 address
Syntax ping6 <IPv6 address> - pings an IPv6 station
Syntax show ipv6 - displays the IPv6 information
Syntax ftp <IPv6 address> - ftp to an IPv6 station
Syntax telnet <IPv6 address> - telnet to an IPv6 station
Chapter 5 – DHCP Server
Syntax - dhcpsrv <start|stop> - start or stop the DHCP server. By default, the server is off
Syntax - config startip=<start ip> endip=<endip> mask=<mask> [dns=< dns1,
dns2,..dns10>] [gateway=<gateway>] [leasetime=<lease time(1..10 hours)>] –
configure the DHCP lease request parameters such as starting IP address, ending IP address, DNS server
parameters, default gateway IP address and lease time
286