Accessing the station manager using the gsm – GE GEFanuc Automation Programmable Control Products TCP/IP Ethernet Communications for the Series 90t-70 PLC GFK-1004B User Manual

Page 130

Advertising

5-3

GFK-1004B

Chapter 5 The Station Manager

a45168

ООООО

TRANSCEIVER

ETHERNET

INTERFACE

STATION MANAGER

SERIES 90-70 PLC

RS-232

SERIAL

LINK

802.3 LAN

GEnet SYSTEM MANAGER

in Local Station Manager Mode

(or an ASCII Terminal)

Must be the REM (Remote)

Command to access Station

Manager with MAC Address

080019010020

MAC Address

080019010020

ООООО

ОООО

TRANSCEIVER

STATION MANAGER

SERIES 90-70 PLC

ETHERNET

INTERFACE

ОООООООО

ОООООО

ОО

Figure 5-3. Station Manager Accessed Remotely over the Network by a GSM in Local

Station Manager Mode using the REM (Remote) Command

Accessing the Station Manager Using the GSM

The Station Manager may be accessed by connecting the Ethernet Interface to a Work-
master or IBM PC Compatible computer running the GSM software in Local or Network
Station Manager mode.

Do either A or B below as desired.

A. Local Connection. Connect the COM1 RS–232 serial port on the device running

the GSM to the 9–pin connector on the Ethernet Interface. Refer to Appendix B,
for instructions on how to make the RS–232 cable.

B. Network Connection. Connect the PC network card on the device running the

GSM to the Ethernet Network.

Power–up the computer running the GSM into DOS. (See Chapter 3. The GEnet
System Manager for installation of the GSM).

Set the PC default directory to the GSM directory, by typing:

C:\> cd gsm

Start–up the GSM by typing:

C:\GSM> gsm

Once the GSM Main Menu appears, go into the Setup GSM functions to set the
Station Manager Mode to Network or Local.

From the GSM Main Menu, cursor to the Access Station Manager function and press
Enter.

A. Local Mode. If you are in Local Mode you will automatically go into the Station

Manager of the locally connected Ethernet Interface.

Advertising

Popular Brands

Popular manuals