GE GEFanuc Automation Programmable Control Products TCP/IP Ethernet Communications for the Series 90t-70 PLC GFK-1004B - Manual (Page 89)

4
section level 1
figure bi level 1
table_big level 1
4-1
GFK-1004B
Chapter 4 Programming Communications Requests
This chapter describes how to program PLC to PLC communications over the Ethernet
Network. Details of the COMMREQ function and the Channel commands are pres-
ented here. The chapter is divided into 5 sections:
H Section 1: The Communications Request
H Section 2: The COMMREQ Function Block and Command Block
H Section 3: Channel Commands
H Section 4: Status Data
H Section 5: Controlling Communications in the Ladder Program
Note
This chapter applies only to PLCs being used as client PLCs to initiate
TCP/IP communications. No programming is required for server
operation.