GE GEFanuc Automation Programmable Control Products TCP/IP Ethernet Communications for the Series 90t-70 PLC GFK-1004B - Manual (Page 234)

D
D-7 GFK-1004B Appendix D Sample DOS System Files
Intel 82593
\CONFIG.SYS
FILES=20
BUFFERS=48
DEVICE=\DOS\HIMEM.SYS
DEVICE=\DOS\EMM386.EXE RAM 1024
DOS=HIGH,UMB
DEVICE=\GEFNDIS\PROTMAN.DOS /I:\GEFNDIS
rem
rem The Ethernet Adapter and its device driver must first be installed
rem into your computer. Replace the string “<DIRECTORY>” in the
rem following DEVICEHIGH command with the directory which contains
rem the specified device driver for your Ethernet Adapter module.
rem
DEVICEHIGH=<DIRECTORY>\I82593.DOS
DEVICEHIGH=\GEFNDIS\GEFNDIS.DOS
\AUTOEXEC.BAT
SET GSMCFG=C:\GSM\CFILES
rem Bind NDIS Drivers
\GEFNDIS\netbind
\GEFNDIS\PROTOCOL.INI
[protocol manager]
DRIVERNAME = PROTMAN$
[GEFNDIS]
DRIVERNAME = GEFNDIS$
BINDINGS = MLM_NIF
MAX_RX_SIZE = 560
NUM_RX_BUFS = 8
; Caution: Interrupt conflicts may arise when using default hardware
; configurations for many Ethernet Adapters. For example,
; interrupt IRQ3 is commonly used for the COM2 serial port
; and most Ethernet adapters.
;
; The following information must match the hardware configuration
; of the Ethernet Adapter as installed on your computer. Please
; modify this information as necessary.
[MLM_NIF]
DRIVERNAME = I82593$$
IOADDRESS = 0x300
INTERRUPT = 15
DMACHAN0 = 6
DMACHAN1 = 7
INBUFFER(K) = 8
OUTBUFFERS(K) = 3