Rs-422 serial interface, Rs-485 serial interface, C d 39 – Genicom EasyCoder 3400e User Manual
Page 103
C d 39
Helvetica CondensedHelvetica
Appendix C— Communications Reference
EasyCoder 3400e Bar Code Label Printer User’s Manual
91
RS-422 Serial Interface
Use the RS-422 interface in long line point-to-point direct connect
installations. The printer cable must have the pin assignments for an
RS-422 serial interface shown in the next table.
RS-485 Serial Interface
Use the RS-485 serial interface for Multi-Drop installations only. The
printer cable must have the pin assignments for an RS-485 serial interface
shown in the next table.
RS-232, RS-422, and RS-485 Serial Interface Pin Assignments
Interface
Pin
Name
Operation
RS-232/422/485
1
Chassis Ground (GND)
Connect to pin 1, chassis ground, of connected device.
RS-232
2
Transmit Data (TD)
Output: Connect to receive data pin of connected device.
RS-232
3
Receive Data (RD)
Input: Connect to transmit data pin of connected device.
RS-232/422/485
4
Request to Send (RTS)
Output: When you use a modem, connect to modem RTS
pin. The modem sets RTS to true before transmission. The
printer sets RTS to false after transmission.
RS-232/422/485
5
Clear to Send (CTS)
Input: When you use a modem, connect to modem CTS
pin. The modem must set CTS true before the printer
transmits data. If not connected, CTS sets itself true.
RS-232/422/485
7
Signal Ground (SG)
To enable communications, connect to signal ground of
connected device. Completes circuit for all RS-232 signals.
RS-232/422/485
11
Printer Status (PS)
Output: When not using software flow control
(XON/XOFF), connect to input of connected device (for
example, CTS). Indicates printer mechanical status and
status of printer input buffer.
RS-422/485
13
Input B
Input: Serial differential data to the printer.
RS-422/485
14
Output A
Output: Serial differential data from the printer.
RS-422/485
16
Input A
Input: Serial differential data to the printer.
RS-422/485
19
Output B
Output: Serial differential data from the printer.
RS-232/422/485
20
Data Terminal Ready
(DTR)
Output: When you use a modem, connect to modem DTR
pin.
When using Intermec Standard Protocol, this pin indicates
that the printer is switched on.
When using XON/XOFF or hardware flow control, this pin
indicates the printer mechanical status and the status of the
printer input buffer.