Genicom EasyCoder 3400e - Manual (Page 17)

C d 39
Helvetica CondensedHelvetica Chapter 1— Getting Started
EasyCoder 3400e Bar Code Label Printer User’s Manual 5
3XXXU.005
Pow er/Data
3400
Ale rt
Feed /Pau
se
Em pty/P
aus e
Intermec Intermec
1
3
2
2 Grasp the front of the media cover with your left hand and lift the front
of the media cover upward to release it from the printer frame.
3 Lift the media cover away from the top of the printer.
Loading Media for Fanfold Printing
Use the sample of fanfold media provided in the Media Envelope to
complete the following procedures. In fanfold printing, you place a stack
of fanfold media at the rear of the printer and feed it into the printer
through a slot in the rear cover. Refer to Chapter 2, “Operating the
Printer,” for instructions on loading rolls of media.
To load media for fanfold printing
1 Open the printer.
2 Disengage the printhead by rotating the head lift lever clockwise until it
releases.
3 Move the supply roll retainer by turning it counterclockwise and sliding
it to the outer end of the supply roll post.
4 Place the fanfold media slightly lower than the slot in the printer back
cover. Line the (box of) fanfold media up with the label path through
the printer. Insert media through the slot at the rear of the printer and
thread it over the supply roll post. See the next illustration.