Adjusting the print darkness, Ar e – Genicom EasyCoder 3400e User Manual
Page 61
C d 39
Helvetica CondensedHelvetica
Chapter 5— Optimizing Printer Performance
EasyCoder 3400e Bar Code Label Printer User’s Manual
49
3XXXU.039
A
R
E
If printing is light on the
right side of label, turn the
bias adjust screw counterclockwise.
If printing is light on
the left side of label, turn
the bias adjust screw clockwise.
A
R
E
3
Replace the media cover.
Adjusting the Print Darkness
Use the darkness adjust control in combination with the PrintSet software
configuration tool to fine-tune the darkness of print on your labels. The
fine adjustments compensate for variations in the media (“lot to lot”), the
printhead, or the printer. Set the darkness adjust control after you enter
the media sensitivity number.
To adjust the print darkness
1
Locate the darkness adjust control on the back of the printer.
2
Use a small straight-slot screwdriver to adjust the print darkness. See the
next illustration.
• To increase the print darkness, turn the control clockwise.
• To decrease the print darkness, turn the control counterclockwise.