Opening the printer, C d 39 – Genicom EasyCoder 3400e User Manual

Page 16

Advertising
background image

Chapter 1— Getting Started

C d 39

Helvetica CondensedHelvetica

4

EasyCoder 3400e Bar Code Label Printer User’s Manual

O

I

O

I

1 2 3 4 5 6 7 8

O

1 2 3 4 5 6 7 8

I

O

I

3XXXU.004

1

2

3

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8

O

I

3

Plug the AC power cord into the receptacle at the rear of the printer.
Plug the other end of the power cord into a grounded wall outlet or
surge protector.

4

Turn the On/Off switch to the on position. When you power on the
printer, the Power On LED lights, the Empty/Pause LED flashes, and
the platen roller advances. The yellow Empty/Pause LED then stays on
steady because you have not loaded media yet.

Opening the Printer

You need to open the printer every time you load media or perform
maintenance procedures.

To open the printer

1

Place the fingers of your right hand between the two notches on the
lower edge of the media cover (the media cover release) and pull the
bottom of the media cover away from the base of the printer. See the
next illustration.

Advertising