Genicom EasyCoder 3400e - Manual (Page 29)

C d 39
Helvetica CondensedHelvetica Chapter 2— Operating the Printer
EasyCoder 3400e Bar Code Label Printer User’s Manual 17
3440U.012
Power/Data
Alert
Empty/Pause
Feed/Pause
Power/Data
Green LED
Alert
Empty/Pause
Off
On
Flashing
Off
Flashing
On
Off
Flashing
On
Power off
Power on
Receiving data
Printing or idle
Over-temperature
System fault
Printing or idle
Paused
Media fault
LED State Indication
Orange LED
Yellow LED
LED states: This illustration shows what each LED state indicates.
LED States for Problems
Problem LED State
Over-Temperature If the printer overheats, the Alert LED flashes and the printer
stops. Do not try to troubleshoot or adjust the printer—just allow
the printer enough time to cool down and it will resume operation
on its own.
Media or System
Faults If the Empty/Pause or the Alert LED remains on, your printer is
experiencing a media or system fault. For help, see Chapter 4,
“Troubleshooting.”
Using the Feed/Pause Button
The Feed/Pause button, located on the front of the printer, performs
several functions depending on the mode of the printer.
Feed/Pause Button Functions
Printer Mode You Want To What to Do
Idle Feed out one label or
a minimum specified
amount of media. Press and release the Feed/Pause button.
Continuously feed
media.
Press and hold the Feed/Pause button.
When you release the button, the media
stops feeding.
Take the printer
offline. Press the Feed/Pause button twice. Press
the button again to bring the printer
online.
Printing Pause the printer. Press and release the Feed/Pause button.
Press and release the button again to
resume printing.
Cancel the current
print job. Press and hold the Feed/Pause button
until the printer stops printing.