Genicom EasyCoder 3400e - Manual (Page 45)

C d 39
Helvetica CondensedHelvetica Chapter 3— Maintaining the Printer
EasyCoder 3400e Bar Code Label Printer User’s Manual 33
Printer Maintenance Schedule (continued)
Printer Component Maintenance Period
Drive roller and tear bar
Media path (not shown)
Edge guide
Upper media guide
Lower media guide
Thermal transfer ribbon
(TTR) assist roller
Self-strip roller
Label gap sensor (not shown)
Label mark sensor (not shown)
Label taken sensor
Pinch roller
Clean after every five rolls of media. If you are
using hi-tack adhesive, you must clean after every
roll of media. If you are using tag stock or
continuous media, you may want to clean after
every five rolls of media or as necessary. Clean
more often in environments that are harsh or
dusty.
3XXXU.032
Power/Data
Intermec Interm
ec
3400
Alert
Fe ed/P
ause
Em pty/P
ause
Tear bar
Drive
roller
Upper media
guide
Lower media
guide
TTR assist
roller
Thermal
printhead
Pinch
roller
Self-strip
roller
Edge
guide
Label taken
sensor
Printer parts: This illustration shows the printer parts that need to be cleaned. For a
maintenance schedule of each part, see the Printer Maintenance Schedule table on
page 32.
Switch off the printer power and remove the power cord before
cleaning any part of the printer.
Avertissement: Mettez l’imprimante hors tension et débranchez le
câble d’alimentation avant de nettoyer une parte de l’imprimante.