Genicom EasyCoder 3400e - Manual (Page 33)

C d 39
Helvetica CondensedHelvetica Chapter 2— Operating the Printer
EasyCoder 3400e Bar Code Label Printer User’s Manual 21
Power/Data
3440
Alert
Fe ed/Pause
Empty/Paus
e
Media
liner
Rewinder
clasp
Rewinder
hub
Self-strip
assist roller
Head lift
lever
Media roll
Supply roll
retainer
➤
➤
➤
Lower media
guide
Media
access door
Supply roll
post
➤
➤
➤
Edge
guide
Upper
media
guide
Intermec Interm
ec
3XXXU.027
Media
support
5 Unscrew the edge guide and slide it to the outer edge of the lower media
guide. Screw it in place.
If you are replacing the empty media roll with a new roll of the same
width, you do not need to adjust the edge guide.
6 Pull down on the lower media guide to allow easy access to the media
path.
7 Unroll several inches of media, insert it between the upper media guide
and the lower media guide, and out the front of the printer.
8 Release the lower media guide and adjust the edge guide to position the
media firmly against the inside wall of the printer.
9 Pull out 25.4 to 30.48 centimeters (10 to 12 inches) of media and
remove the exposed labels from the media liner.
10 Open the media access door and thread the media liner under the self-
strip assist roller and over the rewinder hub in a clockwise direction.
11 Remove the rewinder clasp from the rewinder hub and wind
approximately 5.08 centimeters (2 inches) of media liner clockwise over
the rewinder hub.
12 Secure the media to the rewinder hub by snapping the rewinder clasp
onto the rewinder hub. Turn the rewinder hub clockwise to remove all
slack from the media liner between the tear bar and the rewinder hub.
13 Close the media access door.
14 Rotate the head lift lever counterclockwise until it locks.