Gas-Fired Products Infrared Radiant Tube Heater PTS Series - Manual (Page 25)

Form #43343330
–24– May 08
12.0) ATTACHING BURNER BOX ASSEMBLY
1. Attach the burner box and gasket to end of tube flange and secure with 1/4-20 locknuts.
2. Assemble the optional end reflector flush with the end of the main body reflector. Secure by sliding speed clips
onto the reflector edges. Evenly space the speed clips on the sides (one each side) and top (two required) of the
reflectors to provide a snug fit. Leave a 3" space between the end reflector and the burner box assembly.
3. The heater can be mounted horizontally or at an angle of up to 45 degrees maximum from horizontal.
When angle mounting, the burner box unit must be positioned upright as shown below. FAILURE TO INSTALL THE
BURNER BOX IN AN UPRIGHT POSITION WILL VOID THE MANUFACTURER’S WARRANTY.
Angle Mounting
Straight Tube Heaters
Burner
Box
Upright Position
Angle Mounting
U-Tube Heaters
Burner
Box
Upright Position
Reflector
1/4-20 Locknut
(QTY-3 per flange)
Mounting Flange
24 Hole for Aluminized Steel Tubes
6 Hole for Alumi-Therm Steel Tubes
Tube Flange
Gasket
Speed Clip
(QTY-4)
Optional
End
Reflector
Burner Box
Burner Box Suspension
Eye bolt
Turnbuckle
Failure to install the burner box
suspension chain will void
manufacturers warranty.
DO NOT lift burner or support it’s
weight using the TISS wire. It will
break under heavy load.