Muratec MFX-1500 - Manual (Page 107)

Beyond the basics
2.59
6 Use the numeric keypad to enter your F-Code’s four-digit passcode. Here
we’ve entered 2345:
03:Print F-Code Doc.
F-Code Passcode:2345
7 Press ENTER .
•
If you’ve entered the correct passcode, your fax machine will print all
documents in — and then erase them from — the mailbox.
•
If you’ve entered an incorrect passcode, your fax machine will refuse to
print the document.
F-Code transmission and polling
With F-Code, your machine — in addition to sending Muratec-proprietary
SecureMail (pages 2.39–2.42) and performing database polling (pages 2.30–2.31)
from only other Muratec models — can send secure transmissions to, and perform
database polling from, other makers’ machines, as well. You may accomplish such
transmissions in either of two ways:
•
Programmable one-touch key (see pages 2.68–2.70)
• Direct entry of the ITU - T sub-address and password, which is what we will now
describe.
Whether you are sending to or polling from another machine, you obviously must
know the correct sub-address on the receiving machine, as well as the password if
that sub-address has one. (This is analogous to how, with Muratec SecureMail, you
must know the correct SecureMail mailbox number and password on the remote
Muratec fax.)
Note: For F-Code communication to occur, three things must be true:
• The remote fax machine must support ITU - T sub-addressing (and password)
capabilities.
•
A mailbox with an ITU - T sub-address must exist on the remote fax. (It doesn’t
have to have a password. If the other machine hasn’t at least one box with a sub-
address, F-Code communication will be impossible).
•
You must know the ITU - T sub-address and (if applicable) password information
for the mailbox on the remote machine.
F-Code transmission
1. Press COPY / FAX to change to Fax mode, if necessary.
2. Insert the document.
3. Adjust resolution and contrast if necessary.
4. If you wish to toggle between transmission from the feeder and transmission
from memory, press
MEMORY TRANSMIT .
Note: This toggle affects only a transmission from the ADF . Transmission
from the FBS is always memory transmission.
5. Press COMMUNICATION OPTIONS seven times and then press ENTER .
7.F-Code TX
Comm.Option/Enter
6. Press ENTER .
Enter Sub-Address
_
7. Use the numeric keypad to enter the appropriate sub-address number. In this
example, we’ve entered 123456.
Enter Sub-Address
123456_
Note: If you make a mistake, press CANCEL to back up, then enter the correct
one-digit number.
8. Press ENTER . The display will show:
Enter Password
_
Note: If you know that this sub-address does not have a password, skip to
step 10.
9. Use the numeric keypad to enter the appropriate password number. In this
example, we’ve entered 654321.
Enter Password
654321_
Note: If you make a mistake, press CANCEL to back up, then enter the correct
one-digit number.
10. Press ENTER . The display will show:
Enter Fax Number
_
11. Enter the fax number either by pressing a one-touch key, entering a speed-dial
number or dialling from the numeric keypad. Do not press
START .